<![CDATA[REXYGEN Community Forum / Pull-up / Pull-down Switch]]>2018-11-12T07:35:09ZFluxBBhttp://www.rexygen.com/oldforum/viewtopic.php?id=551<![CDATA[Re: Pull-up / Pull-down Switch]]>Hi tazntex, your approach is absolutely perfect. Did you go through the Getting started guide for REXYGEN on Raspberry Pi? I believe namely the chapter 5 answers your questions.
Kind regards, Jaroslav
]]>http://www.rexygen.com/oldforum/profile.php?id=32018-11-12T07:35:09Zhttp://www.rexygen.com/oldforum/viewtopic.php?pid=2149#p2149<![CDATA[Pull-up / Pull-down Switch]]>Hello, After searching the online manual to find a function block that would allow me to create a "Pull-up" or "Pull-down" switch for use with the raspberry pi gpio pins, any suggestions?
I am using a CNB" function tied to a "GOTO" referencing the GPIO I am pulling low and it is responding but do want to make certain this is the correct way to do so.