setup the CNDR function block according to the screenshot below. Remember also to set parameter "n" (number of (u,y) node pairs) to 5 and parameter "SATF" according to your needs (probably set to 0).

Hope it helps.

Cheers, Tomas

Hmmm that block is a little complicated...  

Are you able to provide a quick example, or point me in the direction of where I might find some that I can reference?

For instance how would I put the configure the block (or multiple blocks) for the following example:

Temperature | Calibration Value
10 degrees:     -0.5
15 degrees:     -0.3
20 degress:     -0.2
30 degrees:     +0.2
40 degrees:     +0.5

and so on.

you can define your calibration curve using CNDR function block - for more details see documentation: https://www.rexcontrols.com/media/doc/E … /CNDR.html

Hope the above is useful for you.

Regards, Tomas

For example, if I pick the two temperature sensors, I currently have a fixed calibration value (offset) of 2.2 degrees, which does bring them pretty close in tracking values, with respect to each other.  However, what I would like to do is be able to set the calibration to 2.2 degrees at 25C and 2 degrees at 30C and so on, creating a calibration curve that more accurately reflects how the sensors track, with respect to each other.

Any thoughts ?