REXYGEN Community Forum / 1-Wire config

Re: 1-Wire config

2015-11-18T15:55:22Z

Did you enable the I2C bus in the /boot/config.txt file? Do you have i2c-dev in your /etc/modules file?

If you don't mind re-flashing your SD card, you might want to use the installation scripts which are available at
https://github.com/rexcontrols/rex-install-rpi
Start with fresh Wheezy image from 2015-05-05, expand the filesystem and follow the installation instructions in the readme.md file.

Re: 1-Wire config

2015-11-18T12:38:53Z

I have setup conf. file as above but no luck....
If I type in the owdir command nothing comes up.

also see below;
[FAIL] Restarting 1-Wire TCP Server: owserver failed! #####this is message from terminal

Re: 1-Wire config

2015-11-17T21:34:21Z

Yes, your conf file is incorrect. The /etc/owfs.conf file should contain these 5 lines for use on the UniPi

!server: server = 127.0.0.1:4304
allow_other
server: port = 127.0.0.1:4304
server: i2c=ALL:ALL
timeout_volatile = 2

Comment or delete the other lines.

1-Wire config

2015-11-17T21:24:30Z

I had to reload rexcore on Pi and all is working except the owserver. When I previously installed the driver I had no issues but this time I cannot seem to get the owserver to load.

Please see attached conf. file, I think the problem lies here but not sure?

Thanks